Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Maintenance of the car
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
6. Cooling systems, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
12.1. Specifications
12.2. Coupling - general information
12.3. A coupling pedal - removal, installation and adjustment
12.4. The main cylinder of coupling - removal, dismantling and installation
12.5. The working cylinder of coupling - removal, dismantling and installation
12.6. The damping cylinder of coupling - removal, dismantling and installation
12.7. A coupling hydraulic actuator - removal
12.8. Coupling mechanism details - removal, dismantling and installation
12.9. The release bearing - replacement
12:10. The directing plug of a main shaft of the check point - replacement
12:11. The driveshaft, a reducer and the back bridge - general information
12:12. Cardan
12:13. An average support - replacement
12:14. Cardan hinges - replacement
12:15. A half shaft, the back wheel bearing and an epiploon - removal and installation.
12:16. A reducer of the back bridge - removal and installation
12:17. An epiploon of the leading gear wheel of a reducer - replacement
12:18. Zadny Bridge - removal and installation
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and elements of finishing
17. System of electric equipment
 





12-11-kardannyjj-val-reduktor-i-zadnijj-most-obshhie-svedeniya.html

12:11. The driveshaft, a reducer and the back bridge - general information

Attention!
Operations on service of the forward bridge see in Hl. 9

On cars the two-section driveshaft with an average support and three cardan hinges from the transmission is installed, a reducer of the back bridge and on an average support. Hinges can be replaced separately. The driveshaft is balanced industrially, at assembly it is not allowed to break its initial orientation concerning other details.
Zadny Bridge consists of a beam, a reducer and half shafts. The reducer transfers rotation from the driveshaft to wheels and is established in a middle part of the bridge. Half shafts have the shlitsevy internal terminations which are inserted into vents of the leading gear wheels of differential of a reducer. The external terminations of half shafts rotate in bearings of back wheels. Dismantling and repair of a reducer are carried out in car service.

11.3 Фиксация карданного вала при отворачивании болтов
11.3 Fixing of the driveshaft at an otvorachivaniye of bolts



"previous page
12:10. The directing plug of a main shaft of the check point - replacement
following page"
12:12. Cardan




9ac83ee2