Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Maintenance of the car
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
6. Cooling systems, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
12.1. Specifications
12.2. Coupling - general information
12.3. A coupling pedal - removal, installation and adjustment
12.4. The main cylinder of coupling - removal, dismantling and installation
12.5. The working cylinder of coupling - removal, dismantling and installation
12.6. The damping cylinder of coupling - removal, dismantling and installation
12.7. A coupling hydraulic actuator - removal
12.8. Coupling mechanism details - removal, dismantling and installation
12.9. The release bearing - replacement
12:10. The directing plug of a main shaft of the check point - replacement
12:11. The driveshaft, a reducer and the back bridge - general information
12:12. Cardan
12:13. An average support - replacement
12:14. Cardan hinges - replacement
12:15. A half shaft, the back wheel bearing and an epiploon - removal and installation.
12:16. A reducer of the back bridge - removal and installation
12:17. An epiploon of the leading gear wheel of a reducer - replacement
12:18. Zadny Bridge - removal and installation
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and elements of finishing
17. System of electric equipment
 






9ac83ee2

12-3-pedal-scepleniya-snyatie-ustanovka-i-regulirovka.html

12.3. A coupling pedal - removal, installation and adjustment

Removal
1. Disconnect a pusher of the main cylinder from a pedal.
2. Turn out the limiter of a pedal or the sensor of switching off of coupling from an arm.
3. Turn off a nut and remove an axis of a pedal (photo).
4. The returning spring
5. Coupling switching off sensor
6. ASCD switch (control cruise)
7. Servopruzhina
8. Pedal
4. Remove a pedal and a spring:
5. Wash out details in solvent and replace those which are strongly worn-out or damaged. The plug is pressed in a pedal therefore in case of the increased wear of the plug all pedal changes.
Installation
6. Installation is carried out upside-down.

2.6 При установке педали смажьте указанные места 1.  Смазать
2.6 At installation of a pedal grease the specified places 1. To grease


3.3 Главный  цилиндр крепится к перегородке моторного отсека
3.3 The main cylinder fastens to a partition of a motor compartment


Attention!
Grease with jellied lubricant a pedal axis, the persistent platform, a servopruzhina and a pin of a pusher of the main cylinder (photo)

Adjustment
7. After installation check height and a free wheeling of a pedal. If necessary adjust, having executed the operations described in Chapter 1.

"previous page
12.2. Coupling - general information
following page"
12.4. The main cylinder of coupling - removal, dismantling and installation