Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Maintenance of the car
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
6. Cooling systems, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
13.1. Specifications
13.2. General information
13.3. The nave automatic interlock device - removal and installation
13.4. Half shafts - removal and installation
13.5. A half shaft - dismantling and assembly
13.6. A nave and a rotary fist - smyaty and installation
13.7. Nave epiploons – removal and installation, adjustment of bearings
13.8. The forward driveshaft - removal and installation
13.9. Epiploons of a forward reducer - replacement
13:10. A forward reducer - removal and installation
13:11. Epiploons of the transfer case - replacement
13:12. The transfer case - removal and installation
13:13. The transfer case - dismantling
14. Brake system
15. Suspension brackets and steering
16. Body and elements of finishing
17. System of electric equipment
 





13-10-perednijj-reduktor-snyatie-i-ustanovka.html

13:10. A forward reducer - removal and installation

1. Lift a front of the car and establish on supports.
2. Merge oil from a reducer.

10.2 Обозначьте положение карданного вала относительно фланца раздаточной коробки
10.2 Designate position of the driveshaft concerning a flange of the transfer case


10. 5 Картер и сальники раздаточной коробки 1. Трубка сапуна 2. Потайная заглушка  3,8,10. Сальник 4. Пробка заправочного отверстия 5. Сливная пробка 6.11. Секция картера 7. Передняя крышка 9. Датчик сигнализации включения переднего моста
10. 5 Carter and epiploons of the transfer case
1. Tube of a sapun
2. Secret cap 
3,8,10. Epiploon
4. Stopper of a filling opening
5. Drain stopper
6.11. Case section
7. Forward cover
9. Sensor of the alarm system of inclusion of the forward bridge


11.5а Разъемы проводов на раздаточной коробке
11:5á Sockets of wires on the transfer case


3. Disconnect the forward driveshaft from a reducer.
4. Turn off bolts of fastening of half shafts to a reducer, displace half shafts and fix by a wire, without allowing sagging on CV JOINTS.
5. Prop up a reducer a support.
6. Turn off bolts of fastening of a reducer (photo).
7. Turn off bolts of support of the engine and you will hang out the engine.
8. Turn off bolts of fastening of a reducer to a frame (photo).
9. Carefully lower a support and get a reducer.
10. Installation is carried out upside-down.

"previous page
13.9. Epiploons of a forward reducer - replacement
following page"
13:11. Epiploons of the transfer case - replacement