Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Maintenance of the car
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
6. Cooling systems, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
13.1. Specifications
13.2. General information
13.3. The nave automatic interlock device - removal and installation
13.4. Half shafts - removal and installation
13.5. A half shaft - dismantling and assembly
13.6. A nave and a rotary fist - smyaty and installation
13.7. Nave epiploons – removal and installation, adjustment of bearings
13.8. The forward driveshaft - removal and installation
13.9. Epiploons of a forward reducer - replacement
13:10. A forward reducer - removal and installation
13:11. Epiploons of the transfer case - replacement
13:12. The transfer case - removal and installation
13:13. The transfer case - dismantling
14. Brake system
15. Suspension brackets and steering
16. Body and elements of finishing
17. System of electric equipment
 






9ac83ee2

13-12-razdatochnaya-korobka-snyatie-i-ustanovka.html

13:12. The transfer case - removal and installation

1. Disconnect the battery from weight.
2. Lift a front of the car and establish on supports.
3. Remove guards of a box and merge oil from a box.
4. Designate provisions of driveshafts concerning flanges of the transfer case, turn off bolts disconnect both driveshafts.
5. Disconnect wires from the sensor of inclusion of the forward bridge and a cable of a speedometer (photo).
6. Remove torsions (Hl. 11).

11.9 Болты крепления раздаточной коробки различаются по размерам (3 нижних показанных на снимке болта длиннее остальных), поэтому перед отворачиванием обозначьте их расположение.
11.9 Bolts of fastening of the transfer case differ by the sizes (3 lower shown in a bolt picture more long than the others) therefore before an otvorachivaniye designate their arrangement.


7. Prop up transmission a support and remove a stretcher.
8. Turn off a nut of fastening of a rod of the transfer case to a control lever (photo) and remove a rod from a hairpin.
9. Establish a support under a case of the transfer case. Turn off bolts of fastening of a box (photo), displace a box back and carefully lower on a floor.
10. Assembly is carried out upside-down. Grease the demountable planes of cases of the transfer case and transmission with structure with number according to the Nissan KP610-00250 catalog, or equivalent. At installation of driveshafts combine the tags put when dismantling.


"previous page
13:11. Epiploons of the transfer case - replacement
following page"
13:13. The transfer case - dismantling