Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Maintenance of the car
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
6. Cooling systems, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
14.1. Specifications
14.2. General information
14.3. Blocks disk (forward and back) brakes - replacement
14.4. A brake support - removal, dismantling and installation
14.5. A brake disk - check, removal and installation
14.6. Back drum brakes - replacement of blocks
14.7. The wheel cylinder of back drum brakes - removal, dismantling and installation
14.8. See hl. 1
14.9. Disks of back brakes - check, removal and installation
14:10. Blocks of the emergency brake (on back disk brakes) - removal, installation and adjustment
14:11. The main cylinder of brakes - removal, dismantling and installation
14:12. The regulator of pressure of brakes - removal and installation
14:13. The highway of a hydraulic actuator - check and replacement
14:14. Pumping of brakes
14:15. The vacuum amplifier of brakes - general information and check
14:16. The vacuum amplifier of brakes - removal and installation
14:17. The emergency brake - adjustment
14:18. The lever of the emergency brake - removal and installation
14:19. Cables of the emergency brake - removal and installation
14:20. The braking signal switch - removal and installation
14:21. Anti-blocking system (ABS) - general information and access to codes.
15. Suspension brackets and steering
16. Body and elements of finishing
17. System of electric equipment
 






9ac83ee2

14-14-prokachka-tormozov.html

14:14. Pumping of brakes

Attention!
Before pumping of brakes on the cars equipped with ABS-system disconnect the battery from weight. It is recommended to pump over brakes together.

1. Need of pumping arises after replacement of details of the highway of a hydraulic actuator. When dismantling a hydraulic actuator of one wheel it is possible to be limited to pumping only of the understanding contour.
2. Lift the car and establish on supports. Press several times a brake pedal. Before pumping restore liquid level in a tank and during pumping support level, without allowing emptying of a tank.
3. Begin pumping with pressure regulator. Turn off it is hard tighten the union for pumping (photo).
4. Attach a hose to the union, lower other end of a hose in a vessel with brake fluid.
5. Ask the assistant to press several times grief of a brake and to hold. Unscrew the union and later 2 sec. after the stream of the liquid following with bubbles weakens, tighten the union. Ask the assistant to release a pedal.
6. Repeat the procedure of 8-9 times until in the following liquid bubbles do not cease to be observed. Tighten the union.
8. Perform these operations on wheel cylinders in the sequence: right back wheels, the left back, right forward, left forward. Upon termination of restore liquid level in a tank.


"previous page
14:13. The highway of a hydraulic actuator - check and replacement
following page"
14:15. The vacuum amplifier of brakes - general information and check