Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Maintenance of the car
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
6. Cooling systems, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
14.1. Specifications
14.2. General information
14.3. Blocks disk (forward and back) brakes - replacement
14.4. A brake support - removal, dismantling and installation
14.5. A brake disk - check, removal and installation
14.6. Back drum brakes - replacement of blocks
14.7. The wheel cylinder of back drum brakes - removal, dismantling and installation
14.8. See hl. 1
14.9. Disks of back brakes - check, removal and installation
14:10. Blocks of the emergency brake (on back disk brakes) - removal, installation and adjustment
14:11. The main cylinder of brakes - removal, dismantling and installation
14:12. The regulator of pressure of brakes - removal and installation
14:13. The highway of a hydraulic actuator - check and replacement
14:14. Pumping of brakes
14:15. The vacuum amplifier of brakes - general information and check
14:16. The vacuum amplifier of brakes - removal and installation
14:17. The emergency brake - adjustment
14:18. The lever of the emergency brake - removal and installation
14:19. Cables of the emergency brake - removal and installation
14:20. The braking signal switch - removal and installation
14:21. Anti-blocking system (ABS) - general information and access to codes.
15. Suspension brackets and steering
16. Body and elements of finishing
17. System of electric equipment
 





14-16-vakuumnyjj-usilitel-tormozov-snyatie-i-ustanovka.html

14:16. The vacuum amplifier of brakes - removal and installation

1. Remove the main cylinder.
2. Disconnect a hose.
3. Disconnect a rod of the amplifier from a brake pedal, having removed an axis (photo).
4. Turn off 4 nuts and get the amplifier from a motor compartment.
5. Installation is carried out upside-down. Before installation of the cylinder check the sizes A and B (photo), if necessary adjust. If at adjustment the size A changed more than on 0,5 mm, then the amplifier replace because of his wear-out.

15.3 Вакуумный усилитель 1. Ось педали 2. Усилитель
15.3 Vacuum amplifier 1. Axis of a pedal 2. Amplifier


15.5 Перед установкой цилиндра проверьте размеры А и В (фото), при необходимости отрегулируйте (на части автомобилей, - см. Технические данные)
15.5 Before installation of the cylinder check the sizes A and B (photo), if necessary adjust (on a part of cars, - see Specifications)


6. Pump over brakes.
7. Check height and a free wheeling of a pedal (Hl. 1)


"previous page
14:15. The vacuum amplifier of brakes - general information and check
following page"
14:17. The emergency brake - adjustment