Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Maintenance of the car
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
6. Cooling systems, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
14.1. Specifications
14.2. General information
14.3. Blocks disk (forward and back) brakes - replacement
14.4. A brake support - removal, dismantling and installation
14.5. A brake disk - check, removal and installation
14.6. Back drum brakes - replacement of blocks
14.7. The wheel cylinder of back drum brakes - removal, dismantling and installation
14.8. See hl. 1
14.9. Disks of back brakes - check, removal and installation
14:10. Blocks of the emergency brake (on back disk brakes) - removal, installation and adjustment
14:11. The main cylinder of brakes - removal, dismantling and installation
14:12. The regulator of pressure of brakes - removal and installation
14:13. The highway of a hydraulic actuator - check and replacement
14:14. Pumping of brakes
14:15. The vacuum amplifier of brakes - general information and check
14:16. The vacuum amplifier of brakes - removal and installation
14:17. The emergency brake - adjustment
14:18. The lever of the emergency brake - removal and installation
14:19. Cables of the emergency brake - removal and installation
14:20. The braking signal switch - removal and installation
14:21. Anti-blocking system (ABS) - general information and access to codes.
15. Suspension brackets and steering
16. Body and elements of finishing
17. System of electric equipment
 





14-2-obshhie-svedeniya.html

14.2. General information

Cars are equipped with brakes with a double-circuit hydraulic actuator, the vacuum amplifier and the regulator of pressure
back brakes (KlSLV - the valve). The regulator is intended for an unblocking of back wheels in the conditions of sharp braking. Works under the influence of a difference of pressure in forward and back contours of brakes in response to change of load of the car.
Forward brakes disk, are equipped with the two-piston or one-piston sliding support.
Back brakes disk or drum. Gaps between blocks and drums are automatically regulated at turning on of the emergency brake. The design of back disk brakes almost differs in nothing from a design of lobbies. The emergency brake is equipped with the hummock drive, turns on from the lever.


"previous page
14.1. Specifications
following page"
14.3. Blocks disk (forward and back) brakes - replacement