Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Maintenance of the car
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
6. Cooling systems, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
14.1. Specifications
14.2. General information
14.3. Blocks disk (forward and back) brakes - replacement
14.4. A brake support - removal, dismantling and installation
14.5. A brake disk - check, removal and installation
14.6. Back drum brakes - replacement of blocks
14.7. The wheel cylinder of back drum brakes - removal, dismantling and installation
14.8. See hl. 1
14.9. Disks of back brakes - check, removal and installation
14:10. Blocks of the emergency brake (on back disk brakes) - removal, installation and adjustment
14:11. The main cylinder of brakes - removal, dismantling and installation
14:12. The regulator of pressure of brakes - removal and installation
14:13. The highway of a hydraulic actuator - check and replacement
14:14. Pumping of brakes
14:15. The vacuum amplifier of brakes - general information and check
14:16. The vacuum amplifier of brakes - removal and installation
14:17. The emergency brake - adjustment
14:18. The lever of the emergency brake - removal and installation
14:19. Cables of the emergency brake - removal and installation
14:20. The braking signal switch - removal and installation
14:21. Anti-blocking system (ABS) - general information and access to codes.
15. Suspension brackets and steering
16. Body and elements of finishing
17. System of electric equipment
 






9ac83ee2

14-9-diski-zadnikh-tormozov-proverka-snyatie-i-ustanovka.html

14.9. Disks of back brakes - check, removal and installation

1. Wrap 2 nuts of a wheel to hold a disk concerning a half shaft flange, and check a condition of a disk (see section 4).
2. Remove the cylinder, turn off bolts of fastening of a mouth to a flange on a beam of the back bridge (photo).
3. Remove a disk. If the disk does not give in, then dig the getting liquid around hairpins, screw bolts in auxiliary openings and wrapping bolts, remove it is wild (photo).
4. Further operations are carried out upside-down. Tighten fastening bolts with set the moment

8.2 Details of a back disk brake of the all-wheel drive Terrano I/Pathfinder car" (since 1988 } 1. Cover of a finger 2. Union Z bolt. Copper laying 4. Hose 5. Kryshna 6. Проклатв internal 7. Cover 8. Cylinder 9. Piston 10 cuff. Piston 11. Cover cylinder


8.3 Снятие диска с помощью вспомогательных болтов 1.Бот М8х125
8.3 Removal of a disk by means of auxiliary bolts 1. M8x125 boat



"previous page
14.8. See hl. 1
following page"
14:10. Blocks of the emergency brake (on back disk brakes) - removal, installation and adjustment