Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Maintenance of the car
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
6. Cooling systems, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
15.1. Specifications
15.2. General information
15.3. Hairpins of fastening of a wheel - replacement
15.4. The stabilizer - removal and installation
15.5. Shock-absorbers - removal and installation
15.6. The torsion - removal and installation
15.7. Bars and extensions of a suspension bracket - removal and installation
15.8. The top lever and a spherical support - removal and installation
15.9. The lower lever and a spherical support - removal and installation
15:10. Springs of a back suspension bracket - removal and installation
15:11. Bars of a back suspension bracket - removal and
15:12. The stabilizer of a back suspension bracket - removal and installation
15:13. Steering - general information
15:14. A wheel - removal and installation
15:15. The lock of a steering column - removal and installation
15:16. A steering reducer - removal and installation
15:17. A steering reducer (the car without hydraulic booster) - dismantling
15:18. Steering
15:19. The pump hydraulic boosters - removal and installation
15:20. Removal of air from a wheel hydraulic actuator
15:21. Steering drafts - removal and installation
15:22. The angles of installation of forward wheels - general information
15:23. Wheels and tires - general information
16. Body and elements of finishing
17. System of electric equipment
 





15-10-pruzhiny-zadnejj-podveski-snyatie-i-ustanovka.html

15:10. Springs of a back suspension bracket - removal and installation

1. Lift a back part of the car and establish supports under a frame.
2. Raise the back bridge the jack substituted under a reducer case.
3. Turn off nuts and remove shock-absorbers from the lower Hairpins (photo).
4. Carefully lower the back bridge before full unloading of springs.
5. Remove springs and cups. Examine cups, at detection of damages replace.

11.2 Отворачивание гаек тяг стабилизатора 1  Тяга
11.2 Otvorachivaniye of nuts of drafts of the stabilizer 1 Draft


9.6 Окрашенный поясок на пружине и метка на нижней части должны быть направлены  а  сторону задней части автомобиля1.  Верх2. Пружина3. Нижняя чашка4. Ориентационные метки5. К задней части автомобиля
9.6 The painted corbel on a spring and a tag on the lower part have to be directed and the party of a back part of the car
1. Top 
2. Spring 
3. Lower cup
4. Orientation tags 
5. To a back part of the car


6. Installation is carried out upside-down. At installation orient springs so that the tag was directed towards a back part of the car (photo). Finally tighten nuts of shock-absorbers after lowering of the car on wheels.


"previous page
15.9. The lower lever and a spherical support - removal and installation
following page"
15:11. Bars of a back suspension bracket - removal and