Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Maintenance of the car
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
6. Cooling systems, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
15.1. Specifications
15.2. General information
15.3. Hairpins of fastening of a wheel - replacement
15.4. The stabilizer - removal and installation
15.5. Shock-absorbers - removal and installation
15.6. The torsion - removal and installation
15.7. Bars and extensions of a suspension bracket - removal and installation
15.8. The top lever and a spherical support - removal and installation
15.9. The lower lever and a spherical support - removal and installation
15:10. Springs of a back suspension bracket - removal and installation
15:11. Bars of a back suspension bracket - removal and
15:12. The stabilizer of a back suspension bracket - removal and installation
15:13. Steering - general information
15:14. A wheel - removal and installation
15:15. The lock of a steering column - removal and installation
15:16. A steering reducer - removal and installation
15:17. A steering reducer (the car without hydraulic booster) - dismantling
15:18. Steering
15:19. The pump hydraulic boosters - removal and installation
15:20. Removal of air from a wheel hydraulic actuator
15:21. Steering drafts - removal and installation
15:22. The angles of installation of forward wheels - general information
15:23. Wheels and tires - general information
16. Body and elements of finishing
17. System of electric equipment
 





15-14-rul-snyatie-i-ustanovka.html

15:14. A wheel - removal and installation

Attention.
Cars of 1996 are equipped with a safety cushion which is in a container in the center of a steering wheel. When working near inertial sensors, a steering column, the dashboard disconnect from the battery of a wire and wait not less than 10 min.

1. Disconnect the battery from weight.
2. Remove or disconnect a container with a safety cushion (if it is provided), having addressed to car service.
3. On cars till 1994 unscrew 2 screws from the back of a wheel (photo), on cars since 1994 of release remove the panel of a sound signal for what unscrew the cross screw-driver screws in the lower part of spokes and remove a collar.
4. Make sure that the wheel is unblocked and turn off a wheel nut.
5. Designate the provision of a wheel concerning a shaft (photo).
6. Vypressuyte a steering wheel, having wrapped stripper bolts in the special openings provided ы to a wheel nave on both parties of a shaft (photo). It is forbidden to remove a wheel blows to a nave.
7. Before installation grease the back rubbing part of a wheel (photo).
8. Installation is carried out upside-down. Combine the put tags, tighten a nut with the set moment and check freedom of rotation of a wheel.


"previous page
15:13. Steering - general information
following page"
15:15. The lock of a steering column - removal and installation