Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Maintenance of the car
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
6. Cooling systems, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
15.1. Specifications
15.2. General information
15.3. Hairpins of fastening of a wheel - replacement
15.4. The stabilizer - removal and installation
15.5. Shock-absorbers - removal and installation
15.6. The torsion - removal and installation
15.7. Bars and extensions of a suspension bracket - removal and installation
15.8. The top lever and a spherical support - removal and installation
15.9. The lower lever and a spherical support - removal and installation
15:10. Springs of a back suspension bracket - removal and installation
15:11. Bars of a back suspension bracket - removal and
15:12. The stabilizer of a back suspension bracket - removal and installation
15:13. Steering - general information
15:14. A wheel - removal and installation
15:15. The lock of a steering column - removal and installation
15:16. A steering reducer - removal and installation
15:17. A steering reducer (the car without hydraulic booster) - dismantling
15:18. Steering
15:19. The pump hydraulic boosters - removal and installation
15:20. Removal of air from a wheel hydraulic actuator
15:21. Steering drafts - removal and installation
15:22. The angles of installation of forward wheels - general information
15:23. Wheels and tires - general information
16. Body and elements of finishing
17. System of electric equipment
 





15-5-amortizatory-snyatie-i-ustanovka.html

15.5. Shock-absorbers - removal and installation

Forward shock-absorbers
1. Turn out wheels, lift a car front. 2. Turn off a rod nut, remove a washer and the plug (photo).
3. Turn off a nut and get a coupling bolt (photo).
4. Installation is carried out upside-down. The head of the lower bolt has to be turned on the car course forward.

1.3 Details of a back suspension bracket of the Pathfinder 1 car. Basic cup of a spring 2. Bar 3. Shock-absorber 4. Cross bar 5. Spring 6. Longitudinal bar 7. Stabilizer 8. Draft of the stabilizer 9. To a forward part of the car


3.3 Перед тем как отвернуть гайку тяги обозначьте зтилки, шайбы и гшокладки
3.3 Before turning off a nut of draft designate ztilka, washers and gshokladka


3.5 Болты кронштейна стабилизатора.
3.5 Stabilizer arm bolts.


Back shock-absorbers
5. Lift a back part of the car for a beam of the bridge and establish on a reliable support.
6. Turn off a nut of the lower fastening of the shock-absorber to an arm of the bridge (photo).
7. Turn off a nut of the top fastening of the shock-absorber and remove the shock-absorber (photo)
8. Finalize shock-absorbers in a former order, tighten nuts after lowering of the car on wheels.


"previous page
15.4. The stabilizer - removal and installation
following page"
15.6. The torsion - removal and installation