Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Maintenance of the car
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
6. Cooling systems, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and elements of finishing
17. System of electric equipment
17.1. Specifications
17.2. General information
17.3. Search of malfunctions - the general of data
17.4. Safety locks - general information
17.5. Fusible crossing points - general information
17.6. The relay - general information
17.7. Switches - check
17.8. Indexes of turns and the alarm system - general information
17.9. Headlights - adjustment
17:10. Headlights - removal and installation
17:11. Lamps - replacement
17:12. A sound signal - check
17:13. A sound signal - removal and installation
17:14. Screenwash - the general of data
17:15. The glass cleaner electric motor - removal and installation
17:16. Windscreen washer - removal and installation
17:17. The block of switches on a steering column - removal and installation
17:18. The ignition switch - removal and installation
17:19. A guard of devices - removal and installation
17:20. The receiver - removal and installation
17:21. The lighter - removal and installation
17:22. The block of switches of lighting - removal and installation
17:23. The switch of the alarm system - removal and installation
17:24. The switch of a heater of back glass - removal and installation
17:25. A thermoelement of heating of back glass - removal and installation
17:26. Safety cushions - general information
17:27. Schemes assembly and electric basic
 






9ac83ee2

17-4-predokhraniteli-obshhie-svedeniya.html

17.4. Safety locks - general information

Chains of electric equipment of the car are protected by safety locks or fusible crossing points (photo). The assembly block of safety locks is mounted under a forward partition on the left side. For access to a safety lock uncover the assembly block. On a cover the chain which is protected by this safety lock is specified. At refusal of a chain at first check a safety lock. The fused safety lock easily is found on appearance. To replace a safety lock get faulty and insert new, having pushed it into a nest. The rated current of a new safety lock has to correspond in accuracy to current of replaced. It is forbidden to use wire pieces instead of a safety lock. At burn-out of a new safety lock find the reason and eliminate.

3.1б Монтажный блок 1. Запасные предохранители 2. Пинцет
3.1b Assembly block 1. Spare safety locks 2. Tweezers


4.2 Если на изоляции перемычки имеются вздутия или следы выкрашивания, или если перемычка перегорела, то ее следует заменить
4.2 If on isolation of a crossing point there are swellings or traces of a vykrashivaniye or if the crossing point fused, then it should be replaced




"previous page
17.3. Search of malfunctions - the general of data
following page"
17.5. Fusible crossing points - general information