Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Maintenance of the car
2.1. Introduction
2.2. Maintenance terms
2.3. An order of performance of adjustments - general comments
2.4. Check of level of liquids
2.5. Check of level of liquid in automatic transmission
2.6. Check of level of liquid of the power steering
2.7. Check of tires (through each 400 kilometers or weekly)
2.8. Care of the battery
2.9. Care of the cooling system
2.10. Check of brushes of screen wipers
2.11. Check of a condition of the hoses located in a motor compartment.
2.12. Check and adjustment of a pedal of a brake
2.13. Replacement of oil and oil filter
2.14. Check and adjustment of gaps of valves
2.15. Lubricant of a running gear and steering
2.16. Check of a suspension bracket and steering
2.17. Check of the driveshaft
2.18. Check of the exhaust system
2.19. Check and adjustment of a pedal of coupling
2.20. Check of level of oil in the manual transmission
2.21. Check of level of oil in the transfer case
2.22. Check of level of oil and karteredifferentsiat (or in a reducer of the back bridge)
2.23. Shift of wheels
2.24. Check of brakes
2.25. Check of fuel system
2.26. Check of the thermostat of the air filter
2.27. Drive belts - check, adjustment and replacement
2.28. Check of seat belts
2.29. Replacement of the air filter and filter of ventilation of a case
2.30. Replacement of the fuel filter
2.31. Replacement of the filter of the ejector valve of system of a dookisleniye exhaust gases
2.32. Replacement of the filter of a tank with an absorber
2.33. Check of fastening of the case of a butterfly valve
2.34. Check and adjustment of turns of idling (engines with fuel injection)
2.35. Replacement of oil in the transfer case
2.36. Replacement of oil in the manual transmission
2.37. Replacement of oil in a reducer back (or forward) the bridge
2.38. Replacement of transmission liquid! in automatic transmission
2.39. Replacement of lubricant in naves of forward wheels and check of bearings (only for rear wheel drive cars)
2.40. Replacement of cooling liquid
2.41. Check and replacement of a zolotnik of ventilation of a case
2.42. Replacement of spark plugs
2.43. High-voltage wires - check and replacement
2.44. A cover of the distributor and the runner of a rotor - check and replacement.
2.45. Check and installation of the moment of ignition.
2.46. Oxygen sensor
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
6. Cooling systems, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and elements of finishing
17. System of electric equipment
 





2-44-kryshka-raspredelitelya-i-begunok-rotora-proverka-i-zamena.html

2.44. A cover of the distributor and the runner of a rotor - check and replacement.

Attention!
The cover of the distributor is recommended to be changed together with candles.

44.1  Винты крышки распределителя
44.1 Distributor cover screws



1. Disconnect an ignition coil wire, unscrew screws (or disconnect latches) and  uncover (photo). Carefully take a cover aside.
2. Check a condition of the runner (photo). At detection of any defects replace the runner for what remove it from a rotor (or turn off a bolt) and establish new (photo).

44.2 Характерные повреждения бегунка распределителя1. Потеря упругости пружинного контакта2. Трешины3. Повреждение из-за задевания за крышку.4. Коррозия
44.2 Characteristic damages of the runner of the distributor
1. Loss of elasticity of spring contact
2. Cracks
3. Damage because of a zadevaniye for a cover.
4. Corrosion


44.3 На двигателях поздних выпускав бегунок крепится болтом
44.3 On engines of late releases the runner fastens a bolt


44.4 Характерные повреждения крышки распределителя1. Скоп гнезда под провод2.  Эрозия выводов3. Износ уголька4,5. След пробоя6. Трещины5. Установите крышку на и затяните винты.
44.4 Characteristic damages of a cover of the distributor
1. Skop of a nest under a wire
2. Erosion of conclusions
3. Wear of a piece of coal 
4,5. Breakdown trace 
6. Cracks
5. Establish a cover on and tighten screws.


3. Check a condition of wires of the switchboard which is built in the distributor.
4. Examine a cover, check existence from the inside of cracks, breakdown traces (which thin burned out of paths), and also wear, a podgoraniye and weakening of contacts (photo). At detection of the slightest signs of a doubtful state replace a cover.

"previous page
2.43. High-voltage wires - check and replacement
following page"
2.45. Check and installation of the moment of ignition.




9ac83ee2