Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Maintenance of the car
2.1. Introduction
2.2. Maintenance terms
2.3. An order of performance of adjustments - general comments
2.4. Check of level of liquids
2.5. Check of level of liquid in automatic transmission
2.6. Check of level of liquid of the power steering
2.7. Check of tires (through each 400 kilometers or weekly)
2.8. Care of the battery
2.9. Care of the cooling system
2.10. Check of brushes of screen wipers
2.11. Check of a condition of the hoses located in a motor compartment.
2.12. Check and adjustment of a pedal of a brake
2.13. Replacement of oil and oil filter
2.14. Check and adjustment of gaps of valves
2.15. Lubricant of a running gear and steering
2.16. Check of a suspension bracket and steering
2.17. Check of the driveshaft
2.18. Check of the exhaust system
2.19. Check and adjustment of a pedal of coupling
2.20. Check of level of oil in the manual transmission
2.21. Check of level of oil in the transfer case
2.22. Check of level of oil and karteredifferentsiat (or in a reducer of the back bridge)
2.23. Shift of wheels
2.24. Check of brakes
2.25. Check of fuel system
2.26. Check of the thermostat of the air filter
2.27. Drive belts - check, adjustment and replacement
2.28. Check of seat belts
2.29. Replacement of the air filter and filter of ventilation of a case
2.30. Replacement of the fuel filter
2.31. Replacement of the filter of the ejector valve of system of a dookisleniye exhaust gases
2.32. Replacement of the filter of a tank with an absorber
2.33. Check of fastening of the case of a butterfly valve
2.34. Check and adjustment of turns of idling (engines with fuel injection)
2.35. Replacement of oil in the transfer case
2.36. Replacement of oil in the manual transmission
2.37. Replacement of oil in a reducer back (or forward) the bridge
2.38. Replacement of transmission liquid! in automatic transmission
2.39. Replacement of lubricant in naves of forward wheels and check of bearings (only for rear wheel drive cars)
2.40. Replacement of cooling liquid
2.41. Check and replacement of a zolotnik of ventilation of a case
2.42. Replacement of spark plugs
2.43. High-voltage wires - check and replacement
2.44. A cover of the distributor and the runner of a rotor - check and replacement.
2.45. Check and installation of the moment of ignition.
2.46. Oxygen sensor
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
6. Cooling systems, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and elements of finishing
17. System of electric equipment
 






9ac83ee2

2-5-proverka-urovnya-zhidkosti-v-avtomaticheskojj-transmissii.html

2.5. Check of level of liquid in automatic transmission

1. Liquid level in automatic transmission has to meet standard, otherwise normal work of transmission is broken and breakages are possible.
2. Transfer the engine to the idling mode, put the lever of the selector in position "Park".

Attention!
After a trip under trying conditions, level is checked not less than 30 min. later after a car stop. The engine has to idle.

3. On heated-up transmission get the probe from a measuring instrument branch pipe. The probe is in a back part of a motor compartment from the passenger (photo).
4. Check to the touch temperature and wipe the probe dry. Insert the probe into place against the stop into a branch pipe.
5. Get the probe and determine level.
6. At a temperature of liquid of 30 - 50 °C level has to be between the marks "cold", and at a temperature of 50 - 80 °C - between the marks "hot" (photo).

5.3 Щуп на автоматической трансмиссии
5.3 The probe on automatic transmission


4.19б Уровень жидкости в бачке сцепления должен находиться между отметками min и шах
4.19b liquid Level has to be in a tank of coupling between the marks min and the shah


If necessary add liquid through a measuring instrument branch pipe, having inserted a funnel with the thin metal gauze. It is necessary to add liquid in the portions until level is not established between the top and lower tags of the probe for the corresponding temperature range. If liquid of dark color, or exudes a burned smell, then it should be replaced.
5.6а Отметки на щупе трансмиссии автомобилей С колесной формулой 4x2...
5.6a Marks in the probe of transmission of cars With a wheel formula 4x2...


5.6б ...и автомобилей С колесной формулой 4x4
5.6b... and cars With a wheel formula 4x4


6.5 Пробка бачка со щупом (двигатель V6)
6.5 A tank stopper with the probe (V6 engine)




"previous page
2.4. Check of level of liquids
following page"
2.6. Check of level of liquid of the power steering