Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Maintenance of the car
3. Четырехцилиндровыв engines
3.1. General information
3.2. Types of the repair work performed without dismantle of the engine from the car
3.3. Order of installation of the piston of the 1st cylinder in compression step VMT.
3.4. A cover of a head of cylinders - removal and installation
3.5. The roller with yokes - removal and installation
3.6. The roller with yokes - dismantling and assembly
3.7. A cam-shaft - removal and installation
3.8. A cam-shaft, support and yokes - check
3.9. Springs of valves and oil scraper caps - replacement
3.10. The soaking-up collector - removal and installation
3.11. A final collector - removal and installation
3.12. A head of cylinders - removal
3.13. A head of cylinders - installation
3.14. The oil pump - removal and installation
3.15. The oil pump - check
3.16. A crankshaft pulley - removal and installation
3.17. A forward epiploon of the crankshaft - replacement
3.18. A forward cover - removal and installation
3.19. A chain and asterisks - removal and installation
3.20. The oil pallet - removal and installation
3.21. A flywheel (a drive plate of the hydrotransformer) - removal and installation
3.22. A back epiploon - replacement
3.23. Engine support - replacement
4. VS engines
5. All engines
6. Cooling systems, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and elements of finishing
17. System of electric equipment
 





3-2-vidy-remontnykh-rabot-vypolnyaemykh-bez-demontazha-dvigatelya-s-avtomobilya.html

3.2. Types of the repair work performed without dismantle of the engine from the car

Without dismantle it is possible to replace laying of the soaking-up and final collectors, laying of the oil pallet, a head of the block of cylinders, epiploons of a bent shaft. It is possible to remove such units as the soaking-up and final collectors, the oil pallet, the oil pump, the pump of cooling liquid, a starter, the generator, the distributor of ignition, gas distribution mechanism detail, units of fuel system and a head of the block of cylinders. In extreme cases when there is no necessary equipment, without removal of the engine it is possible to replace piston rings, pistons, rods and connecting rods. However, it is not recommended to perform these works without dismantle and full dismantling of the engine extremely as cleaning of the accompanying details, and also holding preparatory activities on assembly are required.

"previous page
3.1. General information
following page"
3.3. Order of installation of the piston of the 1st cylinder in compression step VMT.




9ac83ee2