Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Maintenance of the car
3. Четырехцилиндровыв engines
4. VS engines
4.1. General information
4.2. Types of the repair work performed without dismantle of the engine from the car
4.3. Order of installation of the piston of the 1st cylinder in compression step VMT.
4.4. Covers of heads of cylinders – removed and installation
4.5. The roller with yokes - removal and installation
4.6. Hydropushers - removal and installation
4.7. The soaking-up collector - removal and installation
4.8. A final collector - removal and installation
4.9. A pulley - an uspokoitel - removal and
4.10. A gear belt - removal and installation
4.11. A forward epiploon of the crankshaft - replacement
4.12. A cam-shaft epiploon - replacement
4.13. Heads of cylinders - removal and installation
4.14. A cam-shaft - removal and installation
4.15. Details of the valvate mechanism - check
4.16. The oil pallet - removal and installation
4.17. The oil pump - removal, check and installation
4.18. A back epiploon - replacement
4.19. A flywheel (a drive plate of the hydrotransformer) -
4.20. Engine support - replacement
5. All engines
6. Cooling systems, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and elements of finishing
17. System of electric equipment
 





4-1-obshhie-svedeniya.html

4.1. General information

In this Part types of the works on repair of V6 engines performed directly on the car are described. In all described below operations on repair it is meant that the engine is installed on the car.
The engine has V-a figurative arrangement of cylinders and 2 heads (on one on 3 cylinders) located at an angle 60 °. Both cam-shafts (on one in each head) have the drive from a gear belt. Adjustment of a tension of a belt is provided with the sprung roller with the clown. Transfer of effort from a cam-shaft to the valve is provided through the yokes established on rollers and hydropushers. Valves are self-regulating. On each cylinder also 1 final is provided 1 inlet the valve. The crankshaft is cast from malleable cast iron. Covers of radical bearings of the crankshaft are cast in a uniform framework which fastens to a crankshaft case (the block of cylinders). The distributor of ignition has the drive from the spiral gear wheel dressed on a sock of the left cam-shaft. The leading gear wheel of the oil pump is dressed on a crankshaft sock.

"previous page
4. VS engines
following page"
4.2. Types of the repair work performed without dismantle of the engine from the car