Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Maintenance of the car
3. Четырехцилиндровыв engines
4. VS engines
4.1. General information
4.2. Types of the repair work performed without dismantle of the engine from the car
4.3. Order of installation of the piston of the 1st cylinder in compression step VMT.
4.4. Covers of heads of cylinders – removed and installation
4.5. The roller with yokes - removal and installation
4.6. Hydropushers - removal and installation
4.7. The soaking-up collector - removal and installation
4.8. A final collector - removal and installation
4.9. A pulley - an uspokoitel - removal and
4.10. A gear belt - removal and installation
4.11. A forward epiploon of the crankshaft - replacement
4.12. A cam-shaft epiploon - replacement
4.13. Heads of cylinders - removal and installation
4.14. A cam-shaft - removal and installation
4.15. Details of the valvate mechanism - check
4.16. The oil pallet - removal and installation
4.17. The oil pump - removal, check and installation
4.18. A back epiploon - replacement
4.19. A flywheel (a drive plate of the hydrotransformer) -
4.20. Engine support - replacement
5. All engines
6. Cooling systems, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and elements of finishing
17. System of electric equipment
 





4-12-salnik-raspredvala-zamena.html

4.12. A cam-shaft epiploon - replacement

1. Disconnect the battery from weight.
2. Remove the fan and a casing, all belts, pulleys and an uspokoitel.

11.3б ...или съемником, предварительно сместив звездочку и ввернув болт в отверстие на носке коленвала
11:3í... or a stripper, previously having displaced an asterisk and having screwed a bolt in an opening on a crankshaft sock


11.6 Смазка сальника
11.6 Epiploon lubricant


11.7б Запрессовка сальника
11:7í Epiploon Press fitting


3. Turn off a bolt of an asterisk of a cam-shaft (photo).
4. Remove an asterisk.

Attention!
On asterisks there are signs R (right) and the L (left), designating belonging of asterisks to the corresponding cam-shaft. If both asterisks are removed, then do not mix their (photo).

5. Carefully get an epiploon (photo). Press a new epiploon (photo).

12.3 Отворачивание болта звездочки
12.3 Otvorachivaniye of an asterisk bolt


12.5а Извлечение сальника
12:5á Extraction of an epiploon


12.6 Ориентация звездочки при установке на распредвал
12.6 Orientation of an asterisk at installation on a cam-shaft
1. Adjusting tag
2. Index
3. Groove
4. To a forward part of the engine
6. Having established asterisks by the R and L indexes outside (photo).
7. Tighten an asterisk bolt. Other operations are carried out upside-down


"previous page
4.11. A forward epiploon of the crankshaft - replacement
following page"
4.13. Heads of cylinders - removal and installation




9ac83ee2