Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Maintenance of the car
3. Четырехцилиндровыв engines
4. VS engines
4.1. General information
4.2. Types of the repair work performed without dismantle of the engine from the car
4.3. Order of installation of the piston of the 1st cylinder in compression step VMT.
4.4. Covers of heads of cylinders – removed and installation
4.5. The roller with yokes - removal and installation
4.6. Hydropushers - removal and installation
4.7. The soaking-up collector - removal and installation
4.8. A final collector - removal and installation
4.9. A pulley - an uspokoitel - removal and
4.10. A gear belt - removal and installation
4.11. A forward epiploon of the crankshaft - replacement
4.12. A cam-shaft epiploon - replacement
4.13. Heads of cylinders - removal and installation
4.14. A cam-shaft - removal and installation
4.15. Details of the valvate mechanism - check
4.16. The oil pallet - removal and installation
4.17. The oil pump - removal, check and installation
4.18. A back epiploon - replacement
4.19. A flywheel (a drive plate of the hydrotransformer) -
4.20. Engine support - replacement
5. All engines
6. Cooling systems, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and elements of finishing
17. System of electric equipment
 





4-18-zadnijj-salnik-zamena.html

4.18. A back epiploon - replacement

1. Remove transmission (Hl. 7).
2. Remove a flywheel or a drive plate of the hydrotransformer.
3. Hook and carefully get an epiploon (photo).
4. Grease a new epiploon with molybdenic lubricant.
5. Dress an epiploon on the crankshaft and carefully press blows of the hammer with soft brisk.
6. When the surface of an epiploon becomes aflush with the holder, carefully press an epiploon against the stop blows to a brass core (photo).
7. Other operations are carried out upside-down.

18.3 Извлечение заднего сальника
18.3 Extraction of a back epiploon


18.6 Окончательная запрессовка сальника
18.6 Final press fitting of an epiploon



"previous page
4.17. The oil pump - removal, check and installation
following page"
4.19. A flywheel (a drive plate of the hydrotransformer) -