Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Maintenance of the car
3. Четырехцилиндровыв engines
4. VS engines
4.1. General information
4.2. Types of the repair work performed without dismantle of the engine from the car
4.3. Order of installation of the piston of the 1st cylinder in compression step VMT.
4.4. Covers of heads of cylinders – removed and installation
4.5. The roller with yokes - removal and installation
4.6. Hydropushers - removal and installation
4.7. The soaking-up collector - removal and installation
4.8. A final collector - removal and installation
4.9. A pulley - an uspokoitel - removal and
4.10. A gear belt - removal and installation
4.11. A forward epiploon of the crankshaft - replacement
4.12. A cam-shaft epiploon - replacement
4.13. Heads of cylinders - removal and installation
4.14. A cam-shaft - removal and installation
4.15. Details of the valvate mechanism - check
4.16. The oil pallet - removal and installation
4.17. The oil pump - removal, check and installation
4.18. A back epiploon - replacement
4.19. A flywheel (a drive plate of the hydrotransformer) -
4.20. Engine support - replacement
5. All engines
6. Cooling systems, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and elements of finishing
17. System of electric equipment
 





4-20-opory-dvigatelya-zamena.html

4.20. Engine support - replacement

1. Periodically it is necessary to check a condition of support of the engine.
2. For removal of support release nuts and bolts of fastening to arms of the engine and a body on both sides (photo).
3. Raise the engine a jack to provide access to support. At rise you watch closely hoses, cables and wires.
4. Turn off nuts and bolts of support and remove support, having paid attention to orientation of rubber pillows (photo).
5. It is forbidden to turn off nuts on hydraulic support (photo).
6. Installation is carried out upside-down.

20.2 Детали подвески двигателя
20.2 Engine mount details


20.5 Гайки гидравлических опор отворачивать запрещается. 1. Не отворачивать
20.5 Nuts of hydraulic support are forbidden to be turned off. 1. Not to turn off



"previous page
4.19. A flywheel (a drive plate of the hydrotransformer) -
following page"
5. All engines