Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Maintenance of the car
3. Четырехцилиндровыв engines
4. VS engines
4.1. General information
4.2. Types of the repair work performed without dismantle of the engine from the car
4.3. Order of installation of the piston of the 1st cylinder in compression step VMT.
4.4. Covers of heads of cylinders – removed and installation
4.5. The roller with yokes - removal and installation
4.6. Hydropushers - removal and installation
4.7. The soaking-up collector - removal and installation
4.8. A final collector - removal and installation
4.9. A pulley - an uspokoitel - removal and
4.10. A gear belt - removal and installation
4.11. A forward epiploon of the crankshaft - replacement
4.12. A cam-shaft epiploon - replacement
4.13. Heads of cylinders - removal and installation
4.14. A cam-shaft - removal and installation
4.15. Details of the valvate mechanism - check
4.16. The oil pallet - removal and installation
4.17. The oil pump - removal, check and installation
4.18. A back epiploon - replacement
4.19. A flywheel (a drive plate of the hydrotransformer) -
4.20. Engine support - replacement
5. All engines
6. Cooling systems, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and elements of finishing
17. System of electric equipment
 






9ac83ee2 Продать сельхозтехнику на сайте shnick.ru.
Купить обои тут.
арбитраж представительство в суде
Развивающие и Логические игры для детей-погодок.

4-3-poryadok-ustanovki-porshnya-1-go-cilindra-v-vmt-takta-szhatiya.html

4.3. Order of installation of the piston of the 1st cylinder in compression step VMT.

1. For installation of the piston of the 1st cylinder in compression step VMT on a pulley of the crankshaft the corresponding marks are provided.
2. Apply a tag under a conclusion of a wire of a candle of the 1st cylinder on the case of the distributor.
3. Uncover the distributor.
4. Turn the crankshaft so that the mark in a pulley was combined with the index (photo).
5. If the runner indicates the tag put on the distributor case, then the piston 1 - го the cylinder is in compression step VMT. Otherwise tighten the crankshaft on one whole revolution clockwise (360 °) and install the piston 1 - го the cylinder in compression step VMT.
6. Now it is possible to expose in VMT of a step of compression and other pistons, turning the crankshaft on 120 ° and observing an operating procedure of cylinders.

"previous page
4.2. Types of the repair work performed without dismantle of the engine from the car
following page"
4.4. Covers of heads of cylinders – removed and installation