Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Maintenance of the car
3. Четырехцилиндровыв engines
4. VS engines
4.1. General information
4.2. Types of the repair work performed without dismantle of the engine from the car
4.3. Order of installation of the piston of the 1st cylinder in compression step VMT.
4.4. Covers of heads of cylinders – removed and installation
4.5. The roller with yokes - removal and installation
4.6. Hydropushers - removal and installation
4.7. The soaking-up collector - removal and installation
4.8. A final collector - removal and installation
4.9. A pulley - an uspokoitel - removal and
4.10. A gear belt - removal and installation
4.11. A forward epiploon of the crankshaft - replacement
4.12. A cam-shaft epiploon - replacement
4.13. Heads of cylinders - removal and installation
4.14. A cam-shaft - removal and installation
4.15. Details of the valvate mechanism - check
4.16. The oil pallet - removal and installation
4.17. The oil pump - removal, check and installation
4.18. A back epiploon - replacement
4.19. A flywheel (a drive plate of the hydrotransformer) -
4.20. Engine support - replacement
5. All engines
6. Cooling systems, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and elements of finishing
17. System of electric equipment
 





4-5-valik-s-koromyslami-snyatie-i-ustanovka.html

4.5. The roller with yokes - removal and installation

1. Uncover a head of cylinders.
2. In 2-3 receptions release bolts of the roller of yokes, as it should be from the end to the middle. Keep in mind that some the valve are open and yokes are under pressure of springs. Therefore release bolts gradually, otherwise the roller is deformed (photo).

5.2 Болты валика коромысел
5.2 Bolts of the roller of yokes


5.4 Снятие валика  с  коромыслами. Порядок проверки деталей описан ниже.
5.4 Removal of the roller with yokes. The procedure for test of details is described below.


6.2 Фиксация гидротолкателей
6.2 Fixing of hydropushers


6.3 Снятие корпуса с гидротолкателями
6.3 Removal of the case with hydropushers


3. Turn out bolts and you store in an order of their installation (photo).
4. Remove the roller with yokes (photo).
5. Installation is carried out upside-down. Tighten bolts evenly with the set moment, as it should be from the periphery to the middle.

"previous page
4.4. Covers of heads of cylinders – removed and installation
following page"
4.6. Hydropushers - removal and installation




9ac83ee2