Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Maintenance of the car
3. Четырехцилиндровыв engines
4. VS engines
4.1. General information
4.2. Types of the repair work performed without dismantle of the engine from the car
4.3. Order of installation of the piston of the 1st cylinder in compression step VMT.
4.4. Covers of heads of cylinders – removed and installation
4.5. The roller with yokes - removal and installation
4.6. Hydropushers - removal and installation
4.7. The soaking-up collector - removal and installation
4.8. A final collector - removal and installation
4.9. A pulley - an uspokoitel - removal and
4.10. A gear belt - removal and installation
4.11. A forward epiploon of the crankshaft - replacement
4.12. A cam-shaft epiploon - replacement
4.13. Heads of cylinders - removal and installation
4.14. A cam-shaft - removal and installation
4.15. Details of the valvate mechanism - check
4.16. The oil pallet - removal and installation
4.17. The oil pump - removal, check and installation
4.18. A back epiploon - replacement
4.19. A flywheel (a drive plate of the hydrotransformer) -
4.20. Engine support - replacement
5. All engines
6. Cooling systems, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and elements of finishing
17. System of electric equipment
 





4-8-vypusknojj-kollektor-snyatie-i-ustanovka.html

4.8. A final collector - removal and installation

1. Disconnect the battery from weight, remove the air filter.
2. Lift the car and establish on supports.
3. Disconnect a forward exhaust pipe from a collector.
Removal of the right collector
4. Remove thermal guards (photo).
5. Turn off nuts of a collector (photo).
6. Raise a back part of a collector and remove a collector.
Left collector
7. Turn off bolts of a thermal guard (photo).
8. Disconnect a recirculation tube.
9. Working from below, turn off three nuts from above and from below and disconnect an exhaust pipe (a photo 8.5).
10. Get a collector from a motor compartment.
Installation
11. Clear a collector of the consolidation remains.

8.5 Последовательность отпускания гаек выпускных коллекторов1. Правого коллектора2. Левого коллектора3,4 Передняя часть
8.5 Sequence of an otpuskaniye of nuts of final collectors
1. Right collector
2. Left collector 
3,4 Forward part


8.7 Детали левого выпускного коллектора1. Трубка рециркуляции2. Прокладка
8.7 Details of the left final collector
1. Recirculation tube
2. Laying


12. Establish new laying on a head of cylinders. Tighten bolts and nuts in the specified sequence (photo).
13. Other operations are carried out upside-down.

"previous page
4.7. The soaking-up collector - removal and installation
following page"
4.9. A pulley - an uspokoitel - removal and