Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Maintenance of the car
3. Четырехцилиндровыв engines
4. VS engines
4.1. General information
4.2. Types of the repair work performed without dismantle of the engine from the car
4.3. Order of installation of the piston of the 1st cylinder in compression step VMT.
4.4. Covers of heads of cylinders – removed and installation
4.5. The roller with yokes - removal and installation
4.6. Hydropushers - removal and installation
4.7. The soaking-up collector - removal and installation
4.8. A final collector - removal and installation
4.9. A pulley - an uspokoitel - removal and
4.10. A gear belt - removal and installation
4.11. A forward epiploon of the crankshaft - replacement
4.12. A cam-shaft epiploon - replacement
4.13. Heads of cylinders - removal and installation
4.14. A cam-shaft - removal and installation
4.15. Details of the valvate mechanism - check
4.16. The oil pallet - removal and installation
4.17. The oil pump - removal, check and installation
4.18. A back epiploon - replacement
4.19. A flywheel (a drive plate of the hydrotransformer) -
4.20. Engine support - replacement
5. All engines
6. Cooling systems, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and elements of finishing
17. System of electric equipment
 





4-9-shkiv-uspokoitel-snyatie-i.html

4.9. A pulley - an uspokoitel - removal and

1. Disconnect the battery from weight.
2. Remove the fan with a casing and drive belts.

9.4 Болт шкива - успокоителя
9.4 A pulley bolt - an uspokoitel


9.5 Используя частично вывернутый болт шкива в качестве опоры, снимите шкив съемником
9.5 Using partially turned out pulley bolt as a support, remove a pulley a stripper


8.12 Последовательность затягивания гаек выпускных коллекторов 1. Правого 2. Левого
8.12 Sequence of tightening of nuts of final collectors 1. Right 2. Left


3. Designate the provision of pulleys concerning an uspokoitel, turn off bolts and remove pulleys.
4. Release a bolt of an uspokoitel (photo) for what remove a starter and record a flywheel.
5. Using partially turned out pulley bolt as a support, remove a pulley a stripper (photo).
6. Installation is carried out upside-down. At installation combine a spline with a groove of a pulley and tighten a bolt with the set moment.

"previous page
4.8. A final collector - removal and installation
following page"
4.10. A gear belt - removal and installation