Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Maintenance of the car
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
5.1. General information
5.2. Check of a compression in engine cylinders
5.3. Dismantle of the power unit - a security measure
5.4. The engine - removal and installation
5.5. Capital repairs of the engine - general information
5.6. Restoration of the engine - an alternative
5.7. Capital repairs of the engine - a dismantling order
5.8. A head of the block of cylinders - dismantling.
5.9. Head of the block of cylinders cleanings and check of a state
5.10. A head of cylinders - assembly
5.11. Conrod and piston group dismantle
5.12. The crankshaft - dismantle
5.13. The block of cylinders - cleaning
5.14. The block of cylinders - check of a state
5.15. Rods and pistons - check of a state
5.16. The crankshaft - check of a state
5.17. Radical and conrod bearings - check and selection
5.18. Capital repairs of the engine - an assembly order
5.19. Piston rings - installation
5.20. The crankshaft - installation and check of gaps of radical bearings
5.21. A back epiploon - installation
5.22. Rods and pistons - installation and check of gaps in conrod bearings
5.23. Launch of the engine after repair and a running in
6. Cooling systems, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and elements of finishing
17. System of electric equipment
 






9ac83ee2

5-14-blok-cilindrov-proverka-sostoyaniya.html

5.14. The block of cylinders - check of a state

1. At detection of outer defects (cracks and chips), repair the block or replace. It is recommended to check existence of Internal defects in the block of cylinders for what it is necessary to hand over the block in a workshop of car service.
2. Check ovality and conicity of cylinders, having measured diameter in three planes, in the directions parallel and perpendicular axes of the block (photo). If results differ from standard, then the block should be handed over in a repair workshop. After restoration of the block pistons and rings of the repair sizes will be necessary.
3. If the condition of cylinders accepted wear of the cylinder and a gap between the cylinder and the piston do not exceed the established norms, then cylinders it is required to otkhon-ningovat (photo). Works are recommended to be performed in car service.
4. Check deformation of the demountable plane of the block of cylinders (photo). If the deviation from the plane exceeds norm, then the block should be proshlifovat in a workshop of car service. Thickness of the material removed from the block should not exceed thickness of the material removed from a head. If the total size by which decreased the block an igolovka after grinding exceeds 0,2 mm, then the head and the block should be replaced.

14.3б Примерный вид поверхности цилиндра после хоннингования
14:3í The Approximate type of a surface of the cylinder after a honningovaniye


14.4а Проверка деформации разъемной плоскости блока цилиндров
14:4á Check of deformation of the demountable plane of the block of cylinders


In this case new pistons are selected on marking on the block of cylinders (photo).

"previous page
5.13. The block of cylinders - cleaning
following page"
5.15. Rods and pistons - check of a state