Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Maintenance of the car
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
5.1. General information
5.2. Check of a compression in engine cylinders
5.3. Dismantle of the power unit - a security measure
5.4. The engine - removal and installation
5.5. Capital repairs of the engine - general information
5.6. Restoration of the engine - an alternative
5.7. Capital repairs of the engine - a dismantling order
5.8. A head of the block of cylinders - dismantling.
5.9. Head of the block of cylinders cleanings and check of a state
5.10. A head of cylinders - assembly
5.11. Conrod and piston group dismantle
5.12. The crankshaft - dismantle
5.13. The block of cylinders - cleaning
5.14. The block of cylinders - check of a state
5.15. Rods and pistons - check of a state
5.16. The crankshaft - check of a state
5.17. Radical and conrod bearings - check and selection
5.18. Capital repairs of the engine - an assembly order
5.19. Piston rings - installation
5.20. The crankshaft - installation and check of gaps of radical bearings
5.21. A back epiploon - installation
5.22. Rods and pistons - installation and check of gaps in conrod bearings
5.23. Launch of the engine after repair and a running in
6. Cooling systems, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and elements of finishing
17. System of electric equipment
 





5-21-zadnijj-salnik-ustanovka.html

5.21. A back epiploon - installation

On 4-cylinder engines
1. Grease an epiploon, dress on the crankshaft and carefully press a mandrel or easy blows to a soft pro-rate.
On V6 engines
2. Make a mark of landing of an old epiploon on depth and remove an epiploon from the holder (photo).
3. Clear an epiploon and grease an external edge. Press an epiploon a mandrel, or through two wooden whetstones, having clamped an epiploon between whetstones in a vice. It is also possible to press blows of the hammer through whetstone (photo). The epiploon has to come in the holder without distortions.

20.13  Установка бокового уплотнителя на 4-цилиндровых двигателях
20:13 Installation of a side sealant on 4-cylinder engines


4. Grease working edges of an epiploon and establish the holder on new laying, having greased the platform under the holder sealant (photo). Tighten bolts.

21.2 Выпрессовывание старого сальника
21.2 Vypressovyvany old epiploon


21.3 Запрессовка сальника в держатель
21.3 An epiploon press fitting in the holder


21.4а Смазка рабочих кромок сальника.
21:4á Lubricant of working edges of an epiploon.


21.4б Смазка герметиком площадки под держатель
21:4í Lubricant platform sealant under the holder



"previous page
5.20. The crankshaft - installation and check of gaps of radical bearings
following page"
5.22. Rods and pistons - installation and check of gaps in conrod bearings




9ac83ee2