Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Maintenance of the car
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
6. Cooling systems, heating, ventilation and conditioning
6.1. The cooling system - general information
6.2. Antifreeze - general information
6.3. The thermostat - removal and
6.4. A radiator - removal and installation
6.5. The fan and the coupling - removal and installation
6.6. A tank - removal and
6.7. The pump of cooling liquid - check
6.8. The pump of cooling liquid - removal and installation
6.9. The liquid temperature sensor - check and replacement
6.10. System of heating - general information
6.11. The fan - removal and installation
6.12. A heater radiator - removal and installation
6.13. Air conditioning system - general information
6.14. Air conditioning system - service
6.15. The proofreader of idling - adjustment
6.16. A moisture separator - removal and installation
6.17. The compressor - removal and installation
6.18. The condenser - removal and installation
6.19. The control panel of a heater and the conditioner - removal, installation and adjustment
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and elements of finishing
17. System of electric equipment
 






9ac83ee2

6-1-sistema-okhlazhdeniya-obshhie-svedeniya.html

6.1. The cooling system - general information

The pump, the thermostat, broad tank and hoses (photo) belong to the cooling system a radiator with the safety valve.
Circulation of liquid in the engine is provided with the centrifugal pump mounted in a forward part of the block of cylinders. Heated liquid warms the case of the gate and the soaking-up collector. On cars with automatic transmission in the lower part of a radiator the cooler of transmission liquid is mounted. On cars with the conditioner before a radiator the condenser is installed. Krylchatka of the fan of cooling has the drive from the hydraulic coupling. On a part of cars the temperature regulator is built in the coupling, i.e. the fan turns on after warming up of the engine when the krylchatka is entered into gearing with shaft by means of a thermobimetallic spiral spring. The coupling is non-demountable, care of it is not required.

1.2 Система охлаждения 4-цилиндровых двигателей1.  Термостат2. От отопителя3. К отопителю4. Корпус заслонки5. Клапан термостата
1.2 Cooling system of 4-cylinder engines
1. Thermostat 
2. From a heater
3. To a heater
4. Gate case
5. Thermostat valve


3.5 Правильное положение термостата при установке
3.5 The correct position of the thermostat at installation


3.9 Термостат устанавливается так, чтобы вентиляционный клапан (1) или вибрационный клапан (2) были обращены вверх.
3.9 The thermostat is installed so that the ventilating valve (1) or the vibration valve (2) were turned up.


3.14 Термостат двигателя V6
3.14 V6 engine thermostat



"previous page
6. Cooling systems, heating, ventilation and conditioning
following page"
6.2. Antifreeze - general information