Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Maintenance of the car
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
6. Cooling systems, heating, ventilation and conditioning
6.1. The cooling system - general information
6.2. Antifreeze - general information
6.3. The thermostat - removal and
6.4. A radiator - removal and installation
6.5. The fan and the coupling - removal and installation
6.6. A tank - removal and
6.7. The pump of cooling liquid - check
6.8. The pump of cooling liquid - removal and installation
6.9. The liquid temperature sensor - check and replacement
6.10. System of heating - general information
6.11. The fan - removal and installation
6.12. A heater radiator - removal and installation
6.13. Air conditioning system - general information
6.14. Air conditioning system - service
6.15. The proofreader of idling - adjustment
6.16. A moisture separator - removal and installation
6.17. The compressor - removal and installation
6.18. The condenser - removal and installation
6.19. The control panel of a heater and the conditioner - removal, installation and adjustment
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and elements of finishing
17. System of electric equipment
 





6-11-ventilyator-snyatie-i-ustanovka.html

6.11. The fan - removal and installation

1. Disconnect the battery from weight.
2. Remove a stream for trifles (if it is provided).
3. Disconnect  sockets and a hose from the fan (a photo!
4. Turn off 3 bolts and lower the fan.
5. Installation is carried out upside-down.

11.3а Вентилятор  отопителя1. Электродвигатель2. Колесо3. Добавочный резистор, устанавливается так, чтобы стрелка была направлена вверх.
11:3á Heater Fan
1. Electric motor
2. Wheel
3. The additional resistor, is installed so that the arrow was directed up.



"previous page
6.10. System of heating - general information
following page"
6.12. A heater radiator - removal and installation




9ac83ee2