Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Maintenance of the car
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
6. Cooling systems, heating, ventilation and conditioning
6.1. The cooling system - general information
6.2. Antifreeze - general information
6.3. The thermostat - removal and
6.4. A radiator - removal and installation
6.5. The fan and the coupling - removal and installation
6.6. A tank - removal and
6.7. The pump of cooling liquid - check
6.8. The pump of cooling liquid - removal and installation
6.9. The liquid temperature sensor - check and replacement
6.10. System of heating - general information
6.11. The fan - removal and installation
6.12. A heater radiator - removal and installation
6.13. Air conditioning system - general information
6.14. Air conditioning system - service
6.15. The proofreader of idling - adjustment
6.16. A moisture separator - removal and installation
6.17. The compressor - removal and installation
6.18. The condenser - removal and installation
6.19. The control panel of a heater and the conditioner - removal, installation and adjustment
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and elements of finishing
17. System of electric equipment
 





6-6-bachok-snyatie-i.html

6.6. A tank - removal and

1. Disconnect a hose, raise a tank and disconnect wires (photo).
2. Remove a tank and merge liquid.

5.1а Насос и вентилятор охлаждения на 4-цилиндровых дви-гателях1. Прокладка2. Ремень3. Крыльчатка
5.1a the Pump and the fan of cooling on 4-cylinder engines
1. Laying
2. Belt
3. Krylchatka


5.16 Вентилятор охлаждения на двигателях  V61.  Шкив2. Муфта 3. Крыльчатка
5.16 The cooling fan on V6 engines
1. Pulley                                      
2. Coupling 3. Krylchatka


5.2 Болты крепления крыльчатки и муфты
5.2 Bolts of fastening of a krylchatka and coupling


8.1 Болты расширительного бачка на двигателях V6
8.1 Bolts of a broad tank on V6 engines


3. Install a tank upside-down, add liquid.

7.2 Вентиляционное отверстие насоса охлаждающей жидкости
7.2 Air vent of the pump of cooling liquid


8.5а Болты крепления насоса на 4-цилиндровых двигателях
8.5a Bolts of fastening of the pump on 4-cylinder engines


"previous page
6.5. The fan and the coupling - removal and installation
following page"
6.7. The pump of cooling liquid - check