Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Maintenance of the car
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
6. Cooling systems, heating, ventilation and conditioning
6.1. The cooling system - general information
6.2. Antifreeze - general information
6.3. The thermostat - removal and
6.4. A radiator - removal and installation
6.5. The fan and the coupling - removal and installation
6.6. A tank - removal and
6.7. The pump of cooling liquid - check
6.8. The pump of cooling liquid - removal and installation
6.9. The liquid temperature sensor - check and replacement
6.10. System of heating - general information
6.11. The fan - removal and installation
6.12. A heater radiator - removal and installation
6.13. Air conditioning system - general information
6.14. Air conditioning system - service
6.15. The proofreader of idling - adjustment
6.16. A moisture separator - removal and installation
6.17. The compressor - removal and installation
6.18. The condenser - removal and installation
6.19. The control panel of a heater and the conditioner - removal, installation and adjustment
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and elements of finishing
17. System of electric equipment
 





6-8-nasos-okhlazhdayushhejj-zhidkosti-snyatie-i-ustanovka.html

6.8. The pump of cooling liquid - removal and installation

1. Disconnect the battery from weight and lift the car.
2. Merge cooling liquid.
3. Remove the fan with a casing and belts of hinged units.
4. On V6 engines: remove a pulley of the pump and a pulley - an uspokoitel from the crankshaft, uncover a gear belt.
5. Turn off bolts of fastening of the pump (photo).
6. Remove the pump, remove old consolidation.

7.3 Проверка люфта вала насоса
7.3 Check of a side play of a shaft of the pump


8.5б Болты крепления насоса на двигателях V6
8.5b Bolts of fastening of the pump on V6 engines


8.7 Детали насоса охлаждающей жидкости двигателя V61. Для зэднеприводных а/м2. Прокладка3. Для полноприводных а/м
8.7 Details of the pump of cooling liquid of the V6 engine
1. For zedneprivodny cars                                                      
2. Laying                                                                                 
3. For all-wheel drive cars


7. At assembly grease laying germetiky and establish on faded cylinders (photo).
8. Tighten bolts evenly with the set moment.
9. Other operations are carried out in the return about. Adjust a tension of belts, wash down liquid, warm up дригагель and be convinced of lack of a leak. If necessary add liquid.

"previous page
6.7. The pump of cooling liquid - check
following page"
6.9. The liquid temperature sensor - check and replacement




9ac83ee2