Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Maintenance of the car
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
6. Cooling systems, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
8.1. Specifications
8.2. System of ignition general information
8.3. System of ignition check
8.4. Distributor removal
8.5. Distributor installation
8.6. Sensor of rotation of the crankshaft check
8.7. Ignition coil removal and installation
8.8. System of launch of the engine general information
8.9. System of launch of the engine check
8.10. Starter removal and installation
8.11. Traction relay removal and installation
8.12. Starter replacement of brushes
8.13. System of a charge general information
8.14. Generator leaving and precautionary measures
8.15. System of a charge check
8.16. Generator removal and installation
8.17. Regulator of tension and brush replacement
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and elements of finishing
17. System of electric equipment
 





8-16-generator-snyatie-i-ustanovka.html

8.16. Generator removal and installation

1. Disconnect the battery from weight. Lift a car front.
2. Designate and disconnect wires from generators
Take off a belt.
3. Turn off an adjusting bolt and a bolt of fastening.
4. Get the generator from the bottom.
5. Installation is carried out upside-down.

16.2 Детали генератора (без заднего пылезащитного чехла) 1. Стяжной болт 2. Задняя крышка 3. Щеткодержатель 4. Выпрямитель 5. Корпус переднего подшипника 6. Ротор 7. Регулятор 8. Статор 9. Задний подшипник 10. Передний подшипник 11. Передняя крышка 12. Шк
16.2 Generator details (without back dustproof cover) 1. Coupling bolt 2. Back cover 3. Brush holder 4. Rectifier 5. Case of the forward bearing 6. Rotor 7. Regulator 8. Stator 9. Back bearing 10. Forward bearing 11. Forward cover 12. Шк


16.4 Гайки крепления статора
16.4 Nuts of fastening of the stator


16.5а Расположение щеток перед пайкой
16:5á The Arrangement of brushes before the soldering


16.5б Места пайки щеток
16:5í Places of the soldering of brushes


16.6 Регулятор крепится к выпрямителю пайкой (А) и заклепкой (В)
16.6 The regulator fastens to the rectifier the soldering (A) and a rivet (In)




"previous page
8.15. System of a charge check
following page"
8.17. Regulator of tension and brush replacement




9ac83ee2