Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Maintenance of the car
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
6. Cooling systems, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
8.1. Specifications
8.2. System of ignition general information
8.3. System of ignition check
8.4. Distributor removal
8.5. Distributor installation
8.6. Sensor of rotation of the crankshaft check
8.7. Ignition coil removal and installation
8.8. System of launch of the engine general information
8.9. System of launch of the engine check
8.10. Starter removal and installation
8.11. Traction relay removal and installation
8.12. Starter replacement of brushes
8.13. System of a charge general information
8.14. Generator leaving and precautionary measures
8.15. System of a charge check
8.16. Generator removal and installation
8.17. Regulator of tension and brush replacement
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and elements of finishing
17. System of electric equipment
 





8-5-raspredelitel-ustanovka.html

8.5. Distributor installation

If after removal of the distributor position of the crankshaft was not broken
1. Turn the runner in the situation designated before removal of the distributor.
2. Install the distributor, having slightly turned I run NOC that the flute on the distributor entered gearing with the drive roller
3. If position of the case of the distributor concerning the block did not change, and fixing openings coincided. that the put tags on the runner and on the case of the distributor have to settle down opposite to each other.
4. Tighten fastening bolts with the set moment.
5. Put a cover and attach wires.
6. Check installation of ignition.
If after removal of the distributor position of the crankshaft was broken
7. Expose the piston 1 го the cylinder in the provision of VMT of a step of compression.
8. Install a cover on the distributor. Define the place where a conclusion of a wire of the 1st cylinder of settles down designate a tag on the distributor case.
9. Uncover, turn the runner, having arranged it opposite to a tag.
10. Put a cover and attach wires
11. Check installation of ignition.

"previous page
8.4. Distributor removal
following page"
8.6. Sensor of rotation of the crankshaft check




9ac83ee2