Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Maintenance of the car
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
6. Cooling systems, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and elements of finishing
16.1. Specifications
16.2. Care of loops and locks
16.3. A windshield and motionless glasses of a body - replacement
16.4. Bumpers - removal and installation
16.5. A forward lattice - removal and installation
16.6. A forward apron - removal and installation
16.7. An air inlet lattice - removal and installation
16.8. A forward wing - removal and installation
16.9. Adjustment of a cowl
16:10. A cowl - removal and installation
16:11. Cowl locks - removal and installation.
16:12. A cowl lock drive cable - removal and installation
16:13. A back cover - removal and installation
16:14. The lock of a back cover and a cable of the drive - removal and installation
16:15. The internal panel of a door - removal and installation
16:16. Door glass and a window regulator - removal and installation
16:17. The door lock and handles - removal and installation
16:18. A door - removal and installation
16:19. A window leaf of side glass - removal and installation
16:20. Seats - removal and installation
16:21. Seat belts - general information
16:22. The central section - removal and installation
17. System of electric equipment



16:16. Door glass and a window regulator - removal and installation

1. Remove the internal panel of a door.
2. Turn on 90 ° latches which external facing of a door fastens, raise and remove facing.
3. Remove the plastic water filter.
4. Remove a trench of a window regulator.

18.3 Форточка а/м
18.3 Window leaf of the Terrano I/Pathfinder car

19.1а Отворачивание болтов сиденья
19:1á Otvorachivaniye of seat bolts

19.1б Детали переднего отдельного сиденья 1.  Подголовник. Чтобы снять подголовник отверните облицовочную накладку спинки сиденья 2. Регулятор наклона спинки 3. Регулировка самого механизма не предусмотрена 4.  Провод натяжителя 5. Провод управления регул
19:1í Details of a front separate seat 1. Head restraint. To remove a head restraint turn off a facing overlay of a seatback 2. Regulator of an inclination of a back 3. Adjustment of the mechanism is not provided by 4. Wire of a natyazhitel 5. Wire of management регул

5. Turn off bolts of fastening of glass to a window regulator.
6. Displace glass up and remove.
7. If necessary turn off bolts and get a window regulator through an aperture in a framework of a door (photo).
8. Before assembly grease the rubbing surfaces with a thin layer of a litol.
9. Installation is carried out upside-down. After installation adjust glass. For this purpose expose glass at first parallel to the top trench, and then level on a back trench and tighten bolts. Adjustment of smoothness of the course of glass is provided with turn of a forward trench at the released bolts.

"previous page
16:15. The internal panel of a door - removal and installation
following page"
16:17. The door lock and handles - removal and installation