Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Maintenance of the car
3. Четырехцилиндровыв engines
3.1. General information
3.2. Types of the repair work performed without dismantle of the engine from the car
3.3. Order of installation of the piston of the 1st cylinder in compression step VMT.
3.4. A cover of a head of cylinders - removal and installation
3.5. The roller with yokes - removal and installation
3.6. The roller with yokes - dismantling and assembly
3.7. A cam-shaft - removal and installation
3.8. A cam-shaft, support and yokes - check
3.9. Springs of valves and oil scraper caps - replacement
3.10. The soaking-up collector - removal and installation
3.11. A final collector - removal and installation
3.12. A head of cylinders - removal
3.13. A head of cylinders - installation
3.14. The oil pump - removal and installation
3.15. The oil pump - check
3.16. A crankshaft pulley - removal and installation
3.17. A forward epiploon of the crankshaft - replacement
3.18. A forward cover - removal and installation
3.19. A chain and asterisks - removal and installation
3.20. The oil pallet - removal and installation
3.21. A flywheel (a drive plate of the hydrotransformer) - removal and installation
3.22. A back epiploon - replacement
3.23. Engine support - replacement
4. VS engines
5. All engines
6. Cooling systems, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and elements of finishing
17. System of electric equipment



3.16. A crankshaft pulley - removal and installation

1. Disconnect the battery from weight.
2. Remove a radiator with a casing.

15.4 Проверка зазора в зацеплении шестерен (1), зазора между ведомой шестерней и корпусом насоса (2), осевого люфта (3) и деформации плоскости корпуса (4)
15.4 Check of a gap in gearing of gear wheels (1), a gap between the conducted gear wheel and a pump housing (2), an axial side play (3) and deformation of the plane of the case (4)

16.6 Снятие шкива коленвала
16.6 Removal of a pulley of the crankshaft

3. Remove the lower forward cover.
4. Take off belts.
5. Turn off a pulley bolt, having included transfer or having recorded a flywheel (on the car with automatic transmission).
6. Remove a pulley by means of a stripper (photo).
7. Installation is carried out upside-down. Oil a pulley opening for the engine. Tighten all bolts with the set moments.

"previous page
3.15. The oil pump - check
following page"
3.17. A forward epiploon of the crankshaft - replacement