Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Maintenance of the car
3. Четырехцилиндровыв engines
3.1. General information
3.2. Types of the repair work performed without dismantle of the engine from the car
3.3. Order of installation of the piston of the 1st cylinder in compression step VMT.
3.4. A cover of a head of cylinders - removal and installation
3.5. The roller with yokes - removal and installation
3.6. The roller with yokes - dismantling and assembly
3.7. A cam-shaft - removal and installation
3.8. A cam-shaft, support and yokes - check
3.9. Springs of valves and oil scraper caps - replacement
3.10. The soaking-up collector - removal and installation
3.11. A final collector - removal and installation
3.12. A head of cylinders - removal
3.13. A head of cylinders - installation
3.14. The oil pump - removal and installation
3.15. The oil pump - check
3.16. A crankshaft pulley - removal and installation
3.17. A forward epiploon of the crankshaft - replacement
3.18. A forward cover - removal and installation
3.19. A chain and asterisks - removal and installation
3.20. The oil pallet - removal and installation
3.21. A flywheel (a drive plate of the hydrotransformer) - removal and installation
3.22. A back epiploon - replacement
3.23. Engine support - replacement
4. VS engines
5. All engines
6. Cooling systems, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and elements of finishing
17. System of electric equipment



3.23. Engine support - replacement

1. Periodically it is necessary to check a condition of support of the engine, existence on them of cracks and stratifications.
2. In need of replacement of support release nuts and bolts of fastening of support to arms of the engine and a body on both sides (photo).

23.2 Болты и гайки опор
23.2 Bolts and nuts of support

23.4 Опоры двигателя Z24i
23.4 Z24i engine support

3. You will carefully hang out the engine for eyes (for access to them it is required to remove the air filter) and raise a little to provide access to support. At rise you watch closely hoses, cables and wires.
4. Turn off nuts and bolts of support, having paid attention on! orientation of rubber pillows of support (photo).
5. Establish support upside-down.

"previous page
3.22. A back epiploon - replacement
following page"
4. VS engines