Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Maintenance of the car
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
6. Cooling systems, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
8.1. Specifications
8.2. System of ignition general information
8.3. System of ignition check
8.4. Distributor removal
8.5. Distributor installation
8.6. Sensor of rotation of the crankshaft check
8.7. Ignition coil removal and installation
8.8. System of launch of the engine general information
8.9. System of launch of the engine check
8.10. Starter removal and installation
8.11. Traction relay removal and installation
8.12. Starter replacement of brushes
8.13. System of a charge general information
8.14. Generator leaving and precautionary measures
8.15. System of a charge check
8.16. Generator removal and installation
8.17. Regulator of tension and brush replacement
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and elements of finishing
17. System of electric equipment



8.4. Distributor removal

1. Disconnect from the wire distributor from the ignition coil.
2. Uncover the distributor.
3. Designate position of the runner concerning the case of the distributor (photo)
4. Disconnect wires of the sensor of rotation of the crankshaft (on cars of 198788).
5. Designate the provision of an adjusting bolt of the distributor (photo), turn off 2 bolts of fastening and get the distributor (photo).

3.3 Нанесение метки ориентации бегунка относительно корпуса распределителя, по которой бегунок должен быть установлен при сборке
3.3 Drawing a tag of orientation of the runner concerning the distributor case on which the runner has to be installed at assembly

"previous page
8.3. System of ignition check
following page"
8.5. Distributor installation